Science

Ohm's Law: The One Equation Behind Every Circuit

Ohm's Law: The One Equation Behind Every Circuit

Every electric circuit, from the charger plugged into your phone to the heater warming a workshop, obeys one short equation. In the 1820s the German physicist Georg Ohm found that voltage, current and resistance in a circuit are locked together: change one, and the others must follow. That single relationship, V = I x R, is still the first calculation every electrician and engineer reaches for.

Three quantities that move together

Voltage, measured in volts, is the push that drives electric charge around a circuit. Current, measured in amps, is how much charge actually flows each second. Resistance, measured in ohms, is everything that pushes back: the material of the wire, its length, its thickness and the components in the path. Ohm's law says the current equals the voltage divided by the resistance, I = V / R. Double the voltage across the same resistance and twice as much current flows. Double the resistance and the current halves.

12 volts across 4 ohms: current = 3 amps

Same circuit: power = 36 watts

230 volt heater rated at 2,300 watts: current = 10 amps

Resistance of that heater element: 23 ohms

Car starter motor at 12 volts and 150 amps: 1,800 watts

Power completes the picture

Ohm's law has a partner formula for power, the rate at which electrical energy turns into heat, light or movement: P = V x I. A standard phone charger running at 5 volts and 2 amps delivers 5 x 2 = 10 watts. A fast charger that raises the voltage to 20 volts at 1.5 amps delivers 30 watts, which is why it fills a battery sooner. Run the heater numbers through both formulas and they agree: 230 volts x 10 amps = 2,300 watts, and 230 volts divided by 10 amps gives the element's 23 ohms of resistance.

Why a simple law runs the modern world

The law explains everyday mysteries. A car battery holds only 12 volts, yet the starter motor needs enormous power, so it draws around 150 amps through thick cables: 12 x 150 = 1,800 watts. It also explains why power grids transmit electricity at hundreds of thousands of volts. For a fixed amount of power, raising the voltage lowers the current, and lower current means far less energy wasted heating the wires along the way. And it explains the humble fuse: if a fault drops the resistance in a circuit toward zero, Ohm's law says the current tries to climb without limit, so the fuse melts and breaks the circuit first. Try your own combinations with our Ohm's Law Calculator and watch the three numbers move together.

The same three-way relationship also works in reverse when you are choosing parts. If a small circuit must run from a 9 volt battery and should draw no more than 0.02 amps, the resistor in it needs to be at least 9 / 0.02 = 450 ohms. Electricians lean on this daily when they size cables, because a wire is itself a resistor: the longer and thinner it is, the more voltage it steals from the device at the far end.

All figures computed exactly from V = I x R and P = V x I with the inputs stated in the text. Method references: Khan Academy and Encyclopaedia Britannica (Ohm's law).